Wireless Lan 802.11 Devices/Bluetooth Devices/Short Range Devices; Power Cord Set Requirements; Japanese Power Cord Requirements - HP Slate 21 Pro All-in-One User Manual

Wireless LAN 802.11 devices/Bluetooth devices/Short range devices

Power cord set requirements

The all-in-one power supply is provided with Automatic Line Switching (ALS). This feature allows the
all-in-one to operate on input voltages between 100–120V or 200–240V.
The power cord set (flexible cord or wall plug) received with the all-in-one meets the requirements for
use in the country where you purchased the equipment.
If you need to obtain a power cord for a different country, you should purchase a power cord that is
approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage
and current rating marked on the product. In addition, the cross-sectional area of the wire must be a
minimum of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12
feet (3.6 m). If you have questions about the type of power cord to use, contact an authorized HP
service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon
it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the
cord exits from the product.

Japanese power cord requirements

For use in Japan, use only the power cord received with this product.
CAUTION:
44 Appendix A Agency regulatory notices
Do not use the power cord received with this product on any other products.