Tone Setup; Zone Control - Kenwood DNX7120 Instruction Manual

Audio Control
Tone Setup
You can set aTone curve.
o
Display the Tone screen
See <Equalizer Control> (page 87).
D
Set the Tone
OJ
Tone curve becomes fiat.
rn
Bass adjustment items are displayed.
W
Middle adjustment items are displayed.
[I]
Treble adjustment items are displayed.
[[] Sets the Center frequency.
[]] Sets the level.
[l]
Sets the
Q
factor. (Only Bass and Middle can
be set)
[ill
Bass DC Extend settings. (Only when Bass is
selected)
If turned "On", it extends the bass
center frequency to the low register by
approximately 20%.
W
Returns to the "Equalizer" screen.
88 ,. DNX7120/DDX712/DDX7032
Zone Control
You can set the front and rear audio source.
D
Display Zone Control
Touch in the "Audio
Control Menu" screen (page 86).
OJ
Displays the current source.
rn
Returns to the "Audio Control Menu" screen.
D
Set the Zone Control
W
Turns the Zone Function (that sets different
source sounds for front and rear speakers)
On or Off.
[I]
Switches the front and rear audio sources.
(This button appears when the Zone
function is On.)
Use "Reverse" to change over the front and
rear audio sources.
[[] Sets the front and rear audio source
separately.
(This button appears when the Zone
function is On.)
~
~
• When the rear speaker sound is switched, the audio
source that is output at the AV OUTPUT terminal is also
switched to the same source.
[]] Adjusts the volume of the rear channel.
(This button appears when the Zone
function is On.)
[l]
Returns to the "Audio Control Menu" screen.