Connecting The Bathroom Speakers - Samsung HG40EC890 Installation Manual

Series 8
Table of Contents

Advertisement

You can connect the Bathroom Speakers using the following method.
Connecting through the Variable Output (available without an external amplifier)
¦
TV Rear Panel
1. Connect the
VARIABLE AUDIO OUT
Speaker +
Speaker -
2. Connect the
VOL-CTRL
The maximum speaker output is 4W, 8Ω.
The
VARIABLE AUDIO OUT
y Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure, you can control the volume of the bathroom speakers.
– The jack that connects the Volume Control Box to the TV is a 3.5mm normal Phone jack.
– Volume Control Box switch is a Tact switch.
Setting the Sub AMP Mode
– 0: Turns the Sub AMP function off (PWM off).
– 1: Determines the Sub volume according to the main volume control. the sub volume is determined according to the
Power On Volume, the Min Volume, and the Max Volume values of Hotel Mode.
– 2: Determines the volume according to the bathroom control panel setting.
y Variable Output Port Specifications
– Speaker Wire: Use speaker cable no more than 82 feet (25m) in length.
VOL - DOWN
VOL - UP
( Black /Red 2 )
( White 1 )
[HC890-EU]Install Guide-X0ENG.indd 15

Connecting the Bathroom Speakers

1
2
port of the TV to the Bathroom Wall Speakers of the hotel.
N/C
jack of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
port supports MONO sound out only.
GND
( Shield Wire 3 )
Speaker
VOL+
Volume Control Box
VOL-
Volume Control Box
VOL +
1
3
2
VOL -
15
English
2014-05-22
4:37:11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hg46ec890Hg55ec890Hg60ec890

Table of Contents