Rear panel of the Keypad
qh Brightness adjustment hole (page 29)
The hole is located on the side.
Use a flathead screwdriver to adjust the brightness of
the background of the display window.
qj TO SPEAKERS (page 28)
Connects speaker cords to the speakers in a zone.
qk OUT (page 28)
Connects a CAT5 straight cable to the IN jack of the
subsidiary Keypad when used in a single room.
ql IR IN (page 28)
Connects an optional IR emitter so you can operate the
IR Remote Control for the Keypad by pointing it at the
IR sensor of the connected IR emitter.
w; MODE switch (page 28)
When using two Keypads in a single room, set this
switch to SUB on the subsidiary Keypad.
wa FROM AMPLIFIER (page 28)
Connect speaker cords to the Main Unit.
ws IN (page 28)
Connects a CAT5 cable from the Main Unit to the main