BUILT-IN OUTDOOR GAS GRILLS
A430i, A530i, A540i, A660i, & A790i
Leave these instructions with consumer.
Retain for future reference.
READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION OR USE.
IF YOU SMELL GAS
1. Shut off the gas to the appliance.
2. Extinguish any open ﬂ ame.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your
gas supplier or the ﬁ re department.
CODE AND SUPPLY REQUIREMENTS: This
grill must be installed in accordance with local
codes and ordinances, or, in the absence of local
codes, with the latest National Fuel Gas Code
(ANSI Z223.1/NFPA 54), or Natural Gas and
Propane Storage and Handling Installation Code
This appliance and its dedicated manual shutoff
valve must be disconnected from the gas-supply
piping system when testing the system at pressures
in excess of ½ psig (3.5 kPa).
This appliance must be isolated from the gas-
supply piping system by closing its dedicated
manual shutoff valve during any pressure testing
of the gas-supply system at pressures up to and
including ½ psig (3.5 kPa).
Proper operation of your grill
requires prompt and periodic
maintenance. See the CARE &
CLEANING section for details.
Robert H. Peterson Co. • 14724 East Proctor Avenue • City of Industry, CA 91746
REV 8 - 1401211500
WARNINGS AND SAFETY CODES
1. Do not store or use gasoline or other
ﬂ ammable vapors and liquids in the
vicinity of this or any other appliance.
2. An LP cylinder not connected for use
shall not be stored in the vicinity of this
or any other appliance.
Improper installation, adjustment, alteration,
service, or maintenance can cause injury
or property damage. For proper installation,
refer to the installation instructions. For
assistance or additional information,
consult a qualiﬁ ed professional installer,
service agency, or the gas supplier.
All electrical outlets in the vicinity of the grill must
be properly grounded in accordance with local
codes, or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.1, whichever
Keep all electrical-supply cords and fuel-supply
hoses away from any heated surface.
Certiﬁ ed to: