NordicTrack CTK59020 User Manual page 25

Press the ENTER AGE/WT button again to
9
check for system errors.
If there are no system errors, the words NO SYS-
TEM ERRORS will appear in the main display. If
the words LUBRICATE DECK appear in the main
display, the walking platform should be checked
for adequate lubricant. Follow the instructions in
step 4 on page 29 to lubricate the walking platform
if necessary. Then, refer to HOW TO RESET THE
LUBE REMINDER on this page. If the words IN-
CLINE OVERHEAT ERROR appear in the main
display, press the RESET button. If the same sys-
tem error appears repeatedly, call Customer Care
toll-free at 1-800-201-2109.
Press the ENTER AGE/WT button again and
10
enable or disable the lubrication reminder.
The console can be set to display the words LU-
BRICATE DECK every five minutes when the
walking platform needs to be lubricated. Press the
+ or – button beside the ENTER AGE/WT button
until the words LUBE REMINDER ENABLED ap-
pear in the main display. To turn off the lubrication
reminder, press the + or – button until the words
LUBE REMINDER DISABLED appear.
Press the ENTER AGE/WT button again and
11
enable or disable the safety key.
To require the use of the safety key with the con-
sole, press the + or – button beside the ENTER
AGE/WT button until the words SAFETY KEY EN-
ABLED appear in the main display. To allow the
INCLINE TRAINER to be used without the key,
press the + or – button until the words SAFETY
KEY DISABLED appear. CAUTION: If the safety
key is missing or damaged, call Customer Care
toll-free at 1-800-201-2109, Monday through
Friday, 8 a.m. until 5 p.m. Mountain Time.
Hold down the ENTER AGE/WT button and the
12
RESET button simultaneously for two seconds
to exit the maintenance mode.
To exit the maintenance mode at any time, hold
down the ENTER AGE/WT button and the RESET
button simultaneously for two seconds.
HOW TO RESET THE LUBE REMINDER
If the words LUBRICATE DECK appear in the main
display when the maintenance mode is selected (refer
to step 9 on page 24), follow the steps below to reset
the lube reminder.
Insert the key into the console.
1
Refer to GETTING STARTED on page 14.
Hold down the STOP button and the RESET
2
button simultaneously for three seconds.
24