Nokia A032 User Manual page 62

Command
Comment
Mode
delay
wait
SendCR
Send
56
Each line of the script can be one of the
following types:
Parameter
Comment Text
odd, even or none
seconds
Text String
none
Text String
Action
Inserts text into the script which may be
useful for your future reference.
Comment lines serve no function in the
operation of the script.
Some ISPs require that the serial line be
configured for even or odd parity. In
these cases the Mode command must be
used. The parity of the serial port will be
restored to "none" when the script has
completed execution
Causes the script to stop and wait for
the specified number of seconds. This
may be useful at the start to ensure that
the ISP is ready to activate.
Causes the script to wait until the ISP
sends the specified text string. Typically
the script waits for a log in prompt and a
password prompt. The script will wait for
5 seconds. If the text is not found in that
time, the script is aborted and the log on
attempt fails.
Sends the new line sequence to the ISP.
Sends text to the ISP. It also supports
two special tokens:
$USER
. If one of these tokens is
$PASSWORD
used as the parameter, it will be replaced
by the configured username or password
(from the Internet Access Screen) when
the script is run.
Nokia A032 Advanced User Guide
,