Charge The Battery - Nokia N96 User Manual

2. If the device asks for a PIN
code or lock code, enter it,
and press the left selection
key. The factory setting for
the lock code is 12345.
Your device may have internal
and external antennas. As with
any radio transmitting device,
avoid touching the antenna
area unnecessarily while the
antenna is transmitting or
receiving. Contact with such an
antenna affects the communication quality and may
cause the device to operate at a higher power level
than otherwise needed and may reduce the battery
life.
1 — Cellular antenna
16
2 — Antenna for Bluetooth technology, wireless LAN,
and DVB-H; GPS receiver
Note that the Bluetooth, WLAN, GPS, and DVB-H
antennas are located in the back cover of your device.
If you change the back cover, check that the new cover
includes these antennas, otherwise these connections
stop working.

Charge the battery

1. Connect a compatible charger to a
wall outlet.
2. Connect the power cord to the
device. If the battery is completely
discharged, it may take a while
before the charging indicator
starts scrolling.
3. When the battery is fully charged, the charging
indicator stops scrolling. Disconnect the charger
from the device, then from the wall outlet.
Tip: Disconnect the charger from the wall outlet
when the charger is not in use. A charger that is
connected to the outlet consumes power even
when it is not connected to the device.
© 2008 Nokia. All rights reserved.