Download  Print this page

Mitsubishi Electric PLH-2 Installation Manual Page 24

Air-conditioners.
Hide thumbs

Advertisement

Table of Contents
1
2
SW18
SW17
SW17
a
b
c
SW18
d
e
f
g
24
1
2
h
... 1
... 2
... 3
... 4
i
... 50
7. Electrical work
E
7.3. Remote controller
3) Fitting the upper case
1 Put the upper latches (at two locations) first then fit the upper
case into the lower case as illustrated.
2 To remove the upper case, put a slotted screwdriver tip in the
latches as shown in the diagram then move the screwdriver in the
direction of arrow.
Caution:
Do not move the screwdriver while inserting the tip far into the
latches to prevent broken latches.
Be sure to put the screwdriver tip securely in the latches until a
snap sounds. Loosely inserted screwdriver may fall down.
Note:
The operating section is covered with a protective sheet. Before
using the unit, remember to remove the protective sheet.
7.3. Remote controller
4) Setting the DIP switches
When the upper case of the remote controller is viewed from the back,
DIP switches(SW17,SW18) will apear at the positions shown in the
diagram on the right. Ajust these switches to set the correct remote
control address and other functions.
∗ [ON] - [OFF] DIP switch settings are as shown below :
1 [ON] setting
2 [OFF] setting
Set the remote control addres by adjusting switches 1-6 of SW17.
DIP switch.position for for address and other functions are shown be-
low:
a DIP switches 1-6 are for setting the adress
(All settings are binary: See diagram on right)
b Switching[main][auxiliary] ON : auxiliary / OFF : main
c C System backup ON :present/ OFF: absent
d ON : timer every day / OFF : single day
e ON : filter sign present / OFF : filter sign absent
f Filter sign time setting ON : 2500 Hr/ OFF: 100Hr
g Not yet used
h Examples of addres setting
i (maximum)

Advertisement

Table of Contents

   Also See for Mitsubishi Electric PLH-2

This manual is also suitable for:

2.5kkcMr.slim plh-2kkcMr.slim plh-2.5kkc

Comments to this Manuals

Symbols: 0
Latest comments: