Panasonic DBS 576 User Manual page 27

OR
• Enter the Speed Dial Set/Clear code (default = 710).
3. Enter the PSD bin number (80-99).
4. Enter the phone number you want to be speed-dialed (maximum length = 16
characters). Remember to include the Intercom Level or MCO Code level code
depending on how the system is set up. (Refer to the following table.)
Table 5. Characters allowed when assigning PSD numbers
To insert a . . .
Digit or character
Intercom Level*
MCO Code**
Pause
DP - DTMF Code
SSD Code
Hyphen (-) (Appears when the number is dialed or
checked, but not during programming)
Display Number (Start/Stop) ***
DTMF Conversion After the Other Party Answers
Hyphen (-) (Appears when the number is dialed or
checked, but not during programming.)
* Indicates that the digits that follow are either a feature access code or extension
number. (Do not include if system is set for Intercom Level.)
** Indicates that the digits that follow are for an outside number. (Do not include if
system is set for CO Level.)
** Indicates that the enclosed digits should not be displayed during dialing. Must pre-
cede and follow the digits that you do not want displayed. Example: AUTO*2 555-
4143 AUTO*2
5. Press the HOLD key.
6. Replace the handset or press the ON/OFF key.
To delete a PSD number assigned to a one-touch or soft key
Note: When deleting a PSD number from a non-display phone, be sure to record the
change in your personalized list of PSD numbers. (See Appendix B, "Customized
PSD Bin Numbers" on page 101.)
576-40-750 DBS 576 issued March 2001
2. Setting Up Your Phone
Enter/Press...
0, 1-9, *, #
AUTO * #
AUTO * 0
REDIAL
AUTO * *
AUTO
NN(N)
PROG
AUTO * 2
AUTO * 3 (Version 2.5 and
higher)
27