Chapter 2 - Set Up A New Thor Vm2; Hardware Setup; Software Setup - Honeywell Thor VM2 User Manual

Chapter 2 - Set Up A New Thor VM2
This page lists a quick outline of the steps you might take when setting up a new Thor VM2. More instruction for each step is
listed later in this guide. Please refer to the Thor VM2 Reference Guide for additional information and instruction.
Contact Technical Assistance
Note: Installing or removing accessories should be performed on a clean, well-lit surface. When necessary, protect the work
surface, the Thor VM2, and components from electrostatic discharge.
Caution
Before shipping, the internal UPS battery must be disconnected.
Please refer to the Thor VM2 Reference Guide for details.

Hardware Setup

1. Connect accessories to the
2. Connect cables.
3. Connect power cable to the dock.
4. Secure all cables to the dock with the Strain Relief Cable Clamps.
5. Secure the Thor VM2 in the dock.
6. Press the power switch on the dock.
7. Press the Power key.

Software Setup

Hardware setup should be completed before starting software setup.
1. Set Date and Time
2. Set Power Management
3. Adjust Speaker Volume
4. Pair Bluetooth devices
5. Setup Wireless client parameters - Please refer to the Thor VM2 Reference Guide
6. Setup terminal emulation
Please refer to the Thor VM2 Reference Guide for additional information and instruction.
if you need additional help.
Quick Mount Smart Dock.
parameters
2-1