Installing Your New Appliance - Electrolux ETE5207 User Manual

8

InstaLLInG YoUR neW appLIanCe

TIpS & InforMaTIon!
• For built-in models, refer to the separate booklet.
• To join two E:Line modular fridges together, refer
to the booklet with the connection kit.
adequate ventilation around your refrigerator.
the diagram below shows the recommended airspace to
allow for ventilation of your refrigerator.
If you don't have a cupboard with a rear gap, the
recommended clearance area on top increases from
50mm to 90mm (x) and from 32mm to 72mm (y). When
positioned in a corner area, spacing of at least 350mm
on the hinge side will allow the doors to open enough to
enable the removal of bins and shelves.
Note: For those models with telescopic extension slide-
out bins, the clearance required increases from 350mm
to 550mm for top mount and bottom mount models,
and to 450mm for the all refrigerator model to allow full
access to the bins' contents as well as bin removal.
50mm
Recommended
minimum
airspace
cabinet
door
NOTE: Doors are designed to sit proud of cabinetry
(not flush). The clearances shown above are the
recommended minimum clearances.
The clearance at the rear must not exceed 75mm.
Installing your refrigerator
Your new refrigerator should arrive with the front adjustable
rollers wound down, to tilt the top backwards by about
10mm from upright. this will allow your refrigerator door to
self-close, providing a consistent closed seal.
the stability foot should also be wound fully up so it will
not interfere with the operation of the rollers (see diagram
rear gap
in step 3).
x y
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and
the rollers.
1. Roll the refrigerator into place.
2. the top of the refrigerator should be tilted back by
3. If the refrigerator isn't tilted back, you can adjust the
height
adjustable
front rollers
CaUTIon!
10mm (see diagram on left). this will allow the doors to
self-close providing a consistent door seal.
two front rollers by turning the large, plastic roller nut.
(see diagram below). one turn of the nut increases the
height of the refrigerator by 10mm. If you have difficulty
turning the roller nut, have someone tilt the refrigerator
back, so you have better access. alternatively, you
can access the rollers from the side, using a flat
screwdriver. (see diagram below).
stability foot
wound up
10-15mm
fixed rear
rollers
large plastic
roller nut