Getting Started; Connecting The Control Unit; Connecting The Ac Power Cable - Yamaha Disklavier E3 Classic Operation Manual

Table of Contents

Advertisement

Getting Started

Chapter
2

Connecting the Control Unit

Make sure that the cables extending from the piano is connected to the
appropriate connectors or jacks on the rear panel of the control unit.

Connecting the AC Power Cable

1
Connect the power cord extending from the power supply unit
of the piano to the DC-IN 12V connector of the control unit.
2
Connect the AC power cable extending from the piano to
the AC wall outlet.
12
Note:
The cables should be connected to
the control unit when the Disklavier
is installed. If, however, it is not,
carefully connect them to the
appropriate connectors or jacks on
the rear panel of the control unit.
Note:
Be sure to mount the control unit to
the underside of the bass side key
bed.
Important:
Make sure that the voltage of the AC
wall outlet matches that marked on
the Disklavier's Serial No. plate.

Advertisement

Table of Contents
loading

Table of Contents