Cisco 7965G Administration Manual page 140

Status Menu
To remove current status messages, press the Clear softkey.
To exit the Status Messages screen, press the Exit softkey.
Table 7-2 Status Messages on the Cisco Unified IP Phone 7965G and 7945G
Message Description
BootP server used The phone obtained its IP address from
a BootP server rather than a DHCP
server.
CFG file not found The name-based and default
configuration file was not found on the
TFTP Server.
CFG TFTP Size The configuration file is too large for
Error file system on the phone.
Checksum Error Downloaded software file is corrupted. Obtain a new copy of the phone
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
7-4
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
Possible Explanation and Action
None. This message is informational
only.
The configuration file for a phone is
created when the phone is added to the
Cisco Unified Communications
Manager database. If the phone has not
been added to the
Cisco Unified Communications
Manager database, the TFTP server
generates a
CFG File Not Found
response.
Phone is not registered with
•
Cisco Unified Communications
Manager.
You must manually add the phone
to Cisco Unified Communications
Manager if you are not allowing
phones to auto-register. See the
"Adding Phones with Cisco
Unified Communications
Manager Administration" section
on page 2-11
• If you are using DHCP, verify that
the DHCP server is pointing to the
correct TFTP server.
If you are using static IP
•
addresses, check configuration of
the TFTP server. See the
"Network Configuration Menu"
section on page 4-5
assigning a TFTP server.
Power cycle the phone.
firmware and place it in the TFTPPath
directory. You should only copy files
into this directory when the TFTP
server software is shut down,
otherwise the files may be corrupted.
for details.
for details on
OL-12650-01