CPU Box - Bottom Side View
Figure 4 shows a bottom side view of the CPU Box.
Cooling Fans Air Outlet
The Cooling Fans Inlet and Outlet ensure proper air
circulation to prevent overheating of the CPU Box.
Never cover or block the air inlet or outlet of the cooling
Removable Hard Disk Drive/Solid State Disk
Your computer is supplied with a removable Hard Disk Drive
(HDD) or Solid State Disk (SSD), located inside the HDD/SSD
Drawer and configured as drive C. The HDD is equipped with
a built-in heater that automatically turns on at low tempera-
tures. When the temperature drops below 41°F (5°C), a built-
in heater starts operating to maintain the HDD in working
conditions. If HDD temperature is below 41°F (5°C) during
boot-up, a message is issued indicating that the heater is
starting to operate and slightly delaying start-up.
NOTE: The SSD does not require/include a heater to operate
at low temperatures.
Removing the HDD/SSD Drawer from the CPU Box is easy:
Shut-down the MW810 Mobile Workstation.
Switch-off the Main Power switch located at the rear panel of
the CPU Box (see Figure 2).
Figure 4. CPU Box - Bottom Side View
Cooling Fans Air Inlet