Table of Contents
Advertisement
Adjusting Pos. /Size
1
2
3
4
Note:
If a "Cue" or "Rew" signal from a VCR or DVD player is received, the picture position will shift up or down. This picture
position movement cannot be controlled by the Picture Pos./Size function.
Auto Setup H-Pos/V-Pos, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted when the PC
signal is received.
This setting only operates when a PC signal is input, "Component/RGB-in select" is "RGB" and the
aspect is "16:9".
Using Remote Control
Notes:
• Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright
image with borders and other objects are clearly shown, and then try auto setup again.
• Depending on the signal, out of alignment may occur after Auto Setup. Carry out ¿ ne tuning for the
position/size as required.
• If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz and
1366×768@60Hz), pre-selecting the individual signal in "XGA Mode" (see page 36) may results in
correct Auto Setup.
• Auto Setup does not work well when a signal such as additional information is superimposed out of
valid image period or intervals between synchronizing and image signals are short.
• If Auto Setup cannot adjust correctly, select "Normalise" once and press ACTION ( ), then adjust
Pos. /Size manually.
• If the picture goes off screen in the horizontal direction as a result of performing Auto Setup, perform
Dot Clock adjustment.
Press to display the Pos. /Size menu.
Press to select the menu to adjust.
Press to adjust the menu.
Press to exit from adjust mode.
When
on the remote control is pressed, "Auto Setup" will be executed.
When Auto Setup does not work, "Invalid" is displayed.
Pos. /Size
Normalise
Normal
Auto Setup
H-Pos
0
H-Size
0
0
V-Pos
0
V-Size
0
Clock Phase
0
Dot Clock
1:1 Pixel Mode
Notes:
Unadjustable items are grayed
out.
Adjustable items differ depending
on the input signal and the display
mode.
Off
21
Hide quick links:
Advertisement
Table of Contents
