Brother MFC-9140CDN Basic User's Manual page 128

Error Message
Drum !
Drum Stop
Fuser Error
Jam 2-sided
Jam Inside
Jam Manual Feed
Jam Rear
Jam Tray
Limit Exceeded
Log Access Error
Low Temperature
Manual Feed
No Belt Unit
No HUB Support
118
Cause
The corona wires on the drum
units must be cleaned.
The drum unit or the toner
cartridge and drum unit
assembly is not installed
correctly.
It is time to replace the drum
unit.
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
The fuser unit is too hot.
The paper is jammed
underneath the paper tray or
the fuser unit.
The paper is jammed inside the
machine.
The paper is jammed in the
manual feed slot of the
machine.
The paper is jammed in the
back of the machine.
The paper is jammed in the
paper tray of the machine.
The number of pages you are
allowed to print has been
exceeded. The print job will be
cancelled.
The machine could not access
the print log file in the server.
The room temperature is too
low for the machine to operate.
Manual was selected as the
paper source when there was
no paper in the manual feed
slot.
The belt unit is not installed
correctly.
A USB hub device is
connected to the USB direct
interface.
Action
Clean the corona wires on the drum units (see
Cleaning the corona wires on page 101).
Put the toner cartridge into the drum unit that is
indicated on the Touchscreen. Then reinstall
the toner cartridge and drum unit assembly into
the machine.
Replace the drum unit for the colour indicated
on the Touchscreen. (see Replacing the drum
units on page 83).
Press and hold down
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
See Paper is jammed underneath the paper
tray on page 135.
See Paper is jammed inside the machine
on page 132.
See Paper is jammed in the manual feed slot
on page 128.
See Paper is jammed at the back of the
machine on page 130.
See Paper is jammed in the paper tray
on page 128.
Contact your administrator to check your
Secure Function Lock Settings.
Contact your administrator to check the Store
Print Log to Network settings.
For more information, see Network User's
Guide: Store Print Log to Network
Increase the room temperature to allow the
machine to operate.
Place paper in the manual feed slot (see
Loading paper in the manual feed slot
on page 23).
Reinstall the belt unit (see Replacing the belt
unit on page 88).
Disconnect the USB hub device from the USB
direct interface.
to turn the machine