Table of Contents
Advertisement
Precautions and Limitations
Precautions
o Do not forget passwords or EraseKeys.
o Unlocking is not possible if the password is forgotten. Forgotten passwords cannot
be recovered by Fujitsu.
o Always use long passwords that cannot be easily guessed by third parties.
o Third parties will be able to read and write data when the lock is open. Disconnect the USB
cable when it is not in use and remove the HandyDrive. Disconnect the AC adapter too, if one
is in use.
o Never disconnect the USB cable when passwords are being set or changed. Failure to observe
this may result in unintended passwords being set, rendering the device inaccessible.
o Never disconnect the USB cable when EraseKeys are being set or changed. Failure to observe
this may result in unintended EraseKeys being set, rendering the device inaccessible.
o Do not put the PC in an energy saving mode when a HandyDrive for which a password has
been set is connected.
o Energy saving mode refers to Standby / Suspend modes.
o Do not perform any actions using Password Lock Tool Ver. 1 on a HandyDrive for which a
password has been set using Password Lock Tool Ver.2 except unlocking the drive.
Restrictions
Do not execute the following operations below, when passwords are being entered, set, changed or
deleted with the password lock tool.
o Disconnect the HandyDrive or connect or disconnect other USB devices
o Read/ write files that are stored on the HandyDrive
o Log off from Windows, or switch to another user
o Locked HandyDrives cannot be used when the following applications are in use.
-
Symantec "Norton GoBack(TM)"
-
Hard disk monitoring software, such as system recovery software
Installation
Install this software package using the following procedure below.
1. Close all of the working programs before installation.
2. Log on with the Administrator's account.
3. Double-click Setup.exe to start installation.
4. Click [Next >] when the computer is ready for installation, and the "Welcome to the
InstallShield Wizard for HandyDrive Password Lock Tool" dialog box is displayed.
5. At the "Choose Destination Location" Dialog, you can [Browse] for your own installation
directory, or accept the default directory, by clicking [Next].
6. Click [Finish] when the installation is over and "InstallShield Wizard Completed" dialog box is
displayed.
Note: Make sure the earlier version, if available, is uninstalled before installing this package.
HandyDrive-5 - Operations Manual R.1
Advertisement
Table of Contents
