Troubleshooting - Sony DSX-S100 Operating Instructions Manual

•
24
Tone controls:
Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at I kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)
Power requirements: 12 V DC car battery
(negative ground (earth»
Dimensions: Approx. 178 x 50 x 180 mm
(7118 x
2
x
7
'/8
in) (w/h/d)
Mounting dimensions: Approx. 182 x 53 x 163 mm
(7114
x
2
1 18
x
6
1
/2 in) (w/h/d)
Mass: Approx. 1.0 kg (2 Ib 4 oz)
Supplied accessories:
Card remote commander: RM-X 151
USB connector for iPod XA-50IP
Parts for installation and connections (1 set)
Optional accessories/equipment:
BUS cable (supplied with an RCA pin cord):
Source selector: XA-C40
HD Radio™ tuner: XT-I OOHD
Walkman adaptor XA-50WM
Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.
Design and specifications are subject to change
without notice.
Troubllslooling .
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
If the problem is not solved, visit the following
support site.
Support site
http://esupport.sony.com
http://www.sony.com/mobileAV
General
No power is being supplied to the unit.
• Check the connection or fuse.
• If the unit is turned off and the display disappears, it
cannot be operated with the remote commander.
---. Tum on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The ATT function is activated, or the Telephone ATT
function (when the interface cable of a car telephone
is connected to the ATT lead) is activated.
• The position of the fader control "FADER" is not set
for a 2-speaker system.
No beep sound.
• The beep sound is canceled (page 20).
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
---. Store again into the memory.
• The power supply lead or battery has been
disconnected or it is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If no operation is performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
---. Set "DEMO-OFF' (page 20).
The display disappears from/does not appear
in the display window.
• The dimmer is set "DIMMER-ON" (page 20).
• The display disappears if you press and hold
( SOURCE/OFF).
---. Press
(SOURCE/OFF)
on the unit until the
display appears.
• The connectors are dirty (page 22).