Charging; Operation - Silvercrest SAS 7.4 LI A1 Operating Instructions Manual

Charging

Note:
Check to ensure that the on/off switch 6 has been
slid back (to the position "0") before starting the
charging process.
• Place the hand vacuum cleaner from above into
the wall holder 3, so that the barrel plug 5
slips into the socket on the hand vacuum cleaner.
The charge indicator lamp 7 glows red and the
charging process begins.
Important!
• When the hand vacuum again has enough ener-
gy to vacuum, the charge indicator lamp 7
glows green. This does not mean that the batte-
ries are fully charged. When the charge indica-
tor lamp 7 glows green, it means the batteries
are charged to about 80%.
• When charging is complete, which with fully
discharged batteries can take approx. 5 hours,
the appliance automatically switches to a trickle
charge (maintenance function). Nevertheless, in
order to avoid possible damage to the batteries,
do not leave the appliance permanently con-
nected to the power adapter 4.
• First recharge the batteries when the suction
power of the hand vacuum cleaner is noticeably
weaker and the charge indicator light 7 green
is blinking.
Note:
The hand vacuum cleaner can also be charged
directly via the power adapter 4. For this, remove
the barrel plug 5 with a slight twist from the wall
holder 3 and insert it into the socket on the hand
vacuum cleaner.

Operation

Warning!
The suction opening must always be open and
unblocked. Blockages lead to overheating and da-
mage to the motor.
Tips:
• Make certain that the dust filter 0 is always
inserted before using the appliance.
• As the maximum, suck up only as much liquid as
will fill the dirt container q to the MAX mark.
1. Take the hand vacuum cleaner from the wall hol-
der 3 or, if you do not use the wall holder 3,
remove the barrel plug 5 from the socket.
2. If required, place the appropriate nozzle into the
suction opening:
• the crevice nozzle 2, to clean narrow and
difficult to reach locations.
• the wet suction nozzle 1 to vacuum liquids up.
Note:
After you have vacuumed up liquids, immediately
clean the dirt container q.
Otherwise bacteria and microbes could form in it!
Ensure that the dust filter bag 9 is completely dry
before using the appliance again.
3. To switch the appliance on, slide the on/off
switch 6 forwards. The charge indicator lamp 7
lights up green.
4. When you have finished using it, slide the on/
off switch 6 to the rear.
Note:
Place the hand vaccum cleaner into the wall
holder 3 and start the charging process when
the suction power is noticeably weaker and the
charge indicator light 7 green is blinking.
- 5 -