v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Configuration/Setup Utility menu only.
v System Security
Select this choice to set passwords. See "Passwords" on page 14 for more
information about passwords.
v Advanced Setup
Select this choice to change values for the following advanced hardware
features:
Important: The server might malfunction if these options are incorrectly
configured. Follow the instructions on the screen carefully.
– Memory/Cache Options
Select this choice to enable or disable the microprocessor cache.
Attention:
Do not make changes to the cache control unless directed to do
so by an IBM authorized service representative.
– PnP/PCI Options
Select this option to configure Plug-n-Play and PCI devices.
– CPU Frequency
Select this option to enable or disable the microprocessor cache.
v Power Management
Select this choice to enable or disable system power settings.
v Error Logs
Select this choice to display the POST error log and the System error log. The
System Error Log menu is available only when a Remote Supervisor Adapter is
installed.
v Save Settings
Select this choice to save the changes you have made in the settings.
v Restore Settings
Select this choice to cancel the changes you have made in the settings and
restore the previous settings.
v Load Default Settings
Select this choice to cancel the changes you have made in the settings and
restore the factory settings.
Chapter 2. Configuring your server
13