LG GCE-8160B Owner's Manual page 11

DirectCD TM v2.5b(s)
Jumper
Setup
Before installation, set the jumper on the jumper connector on the
rear panel.
The drive can be connected as the Master or Slave on an EIDE
(ATAPI) interface. When several (up to four) EIDE devices are con-
nected, each must be set in a unique way. Specific knowledge of
hardware and software is necessary to install the drive.
NOTE : If two peripheral devices with the same settings are both
connected to the Primary or to the Secondary EIDE bus, the host
computer may fail to run or may malfunction. Careful attention is
necessary.
NOTE : Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be
damaged.
Master/Slave setting is determined by jumper installation on the
Jumper Connector. The following table shows the possible jumper
settings.
Name
MA
(Master)
SL
(Slave)
CS
(Cable Select)
If you use CSEL setting, the MASTER/SLAVE setting will be made
automatically, depending on the hardware configuration.
For details refer to the manual of your computer.
8
L ANALOG
AUDIO
C S M
G L
S L A
Function
Drive set as Master
Drive set as Slave
Drive mode set by CSEL on the
host IDE interface
CS: Cable Select(CSEL)
SL: Slave
MA: Master
39
40
C S
S L
M
A