Connection; Operation - JTS US-936K Instruction Manual

5. Connection

5-1 Receiver //
(1) Connect to the subsequent unit (e.g. mixer, or amplifier)
Connect one end of a proper AF cable to the AF Output
plug another end to the "MIC IN" input socket of a mixer or a amplifier (Step 1 of Figure 1)
(2) Connect the power supply unit
Plug in one end of AC/DC adaptor cable
receiver, and plug another end into an AC outlet
(Step 2 of Figure 1)
Caution
To prevent accidental disconnection of the plug of the power supply unit from the jack, lead
the cable around the hook for strain relief .
MIXER
Figure 1
7
or AF Output mixed , then
21
20
to Power Supply Jack in the rear panel of
29 22
32
1
AUDIO OUTPUT
AF OUTPUT DCV INPUT AF OUTPUT AF OUTPUT
RX2 12-18V/500mA Mixed RX1
DC INPUT
32
2

6. Operation

6-1 Setting US-936K receiver system
1. Turn on the power to the receiver
(1) Pull the receiver antenna out.
(2) Press the power switch to turn on the power.
1
(3) To turn off: Keep pressing the power switch down; the power is off about 1 second later.
2. Set the preset channels for receiver
Press the Channel Select ▲, ▼ keys to select US-936K preset channels; a total of 225 sets
6
are available. A preset channel is displayed by the LED while the corresponded frequency is
displayed on LCD . Keeping▲ or▼ pressed down can change the channels faster. (Fig.2) 8
3. Frequency key
If to adjust the frequency as you like rather than using a preset channel, press the Frequency key
▼to adjust the frequency at an increment of "+/-" 0.025MHz; keeping the ▲ or ▼ keys pressed down
makes the frequency change faster. (Fig.3)
預設頻道
4. Volume key
Press ▲, ▼ to adjust the volume as needed in the range between 0 and 31dB; keeping the▲ or ▼
3
keys pressed down makes the volume change faster. (Fig.4)
7
Figure 2
▲,
4
Figure 3
Figure 4
8