Setting Up - Bowers & Wilkins Zeppelin Owner's Manual

Setting up

Connect Zeppelin to the power supply. When
plugged in, Zeppelin will go through a system
check for a couple of seconds, during which it will
not accept commands, and then assume standby
mode. In standby, the LED at the front will glow red.
To turn Zeppelin fully on, press the
on the remote handset or on Zeppelin itself. When
fully on, the LED colour will depend on the selected
source – blue for iPod/iPhone or green for a second
source plugged into the AUX socket.
To totally disconnect Zeppelin from the power
supply, you will have to remove the plug from or
switch off the wall outlet.
button, either
8