Disassembly; Cleaning Your Power Juicer - Jack LaLanne's Power Juicer Operating Manual

DISASSEMBLY

IMPORTANT: Before disassembling the unit make sure you turn the power OFF
and unplug the machine from the electrical outlet.
STEP 1:
Remove pusher from the chute.
1
Pusher
Pulp Guard
STEP 3:
Remove lid with pulp guard,
and pulp collector.
3
Lid with Built-in
Pulp Guard
Pulp
Collector
8
STEP 2:
Lower the locking bar (silver) into
position as shown.
2
Locking Bar
STEP 4:
Use the crescent tool (orange) to
remove the blade. Place the two pegs
at either end of the crescent tool into
the two holes on the blade, press
down and turn counter-clockwise
to unlock the blade. Remove
blade carefully.
4
Blade
Crescent Tool
DISASSEMBLY
STEP 5:
Remove filter.
5
Filter
CLEANING YOUR
POWER JUICER
• Turn off the power switch and wait until the motor completely stops.
• With dry hands, unplug the power cord from electrical outlet.
• Disassemble the machine. (See disassembly instructions.)
• Wipe base with a soft damp cloth or sponge. Do not submerge base in water.
Do not spray with water or any other liquid. Base is not dishwasher safe.
• We recommend washing the pusher by hand in warm soapy water. Due to
temperature differences in dishwashers if you choose to wash the pusher in the
dishwasher, place it on top rack only.
• Clean all other parts in warm, soapy water. A mild detergent is recommended.
Rinse well and dry thoroughly. All components are dishwasher safe with the
exception of the base. Do not use in European Import or a commercial dishwasher.
• To clean the filter and blade, hold them under warm running water. Use a soft-
bristled dish washing brush gently to completely clean pulp from filter. Rinse
the filter from the outside under running water.
• Dry components thoroughly then assemble the machine and turn the power
on to spin out any excess water.
• Make sure unit and parts are completely dry then store in a cool, dry place.
(CONT.)
STEP 6:
Remove receptacle from base.
6
Receptacle
Base
9