Camera Adjustment; Cable Connections - Bunker Hill Security 61208 Owner's Manual

Camera adjustment

1. Loosen Adjustment Wheel,
rotate Camera as needed, then
tighten Adjustment Wheel.
2. Loosen Adjustment Screw,
tilt Camera as needed, then
tighten Adjustment Screw.
note: Only loosen Adjustment
Screw slightly, do not remove it.

Cable Connections

CautiOn! Route the Cable so
as to avoid a tripping hazard.
1. Connect Video from Camera to Cable.
2. Connect Power from Camera to Cable.
3. Connect Video from Cable to Video
Input Device (DVR, TV, Monitor, etc).
Page 8
1
2
For technical questions, please call 1-800-444-3353.
adjustment
4. Connect Power from Cable
to Power Adapter.
5. Plug Power Adapter into a
120 volt electrical outlet.
CautiOn! The Power Adapter MUST be
plugged in indoors in a clean, dry location.
Video Input Device
3
Figure e
Wheel
adjustment
Screw
Figure D
4 5
Item 61208