Motorola AP-650 Series Installation Manual: Features

Ap-650 series thin access point.
Hide thumbs

Advertisement

1.5 Features

One RJ-45 connector
LED indicators
Safety wire tie point
Slots for wall mounting
Clips for mounting on a suspended ceiling T-bar
Lock port for Kensington® style Security Lock
The AP-650 Thin Access Point has one RJ-45 connector supporting an 10/100/1000 Ethernet port and
requires 802.3af-compliant power from an external source.
NOTE
The AP-650 Thin Access Point comes in both single and dual radio versions both supporting 802.11a/
b/g/n.
The Thin Access Point contains runtime firmware which enables the unit to boot after either a power
up or a watchdog reset. The runtime firmware on the Thin Access Point and the firmware downloaded
from the switch can be updated via the Ethernet interface from the Wireless Switch.
When operating in a Gigabit Ethernet environment CAT-5e or CAT-6 cable
is required for Gigabit operation.
Introduction
3

Advertisement

   Also See for Motorola AP-650 Series

Comments to this Manuals

Symbols: 0
Latest comments: