Structure Of The Color Temp Adj Menu; Setting Lists In The Color Temp Adj Menu - Sony Trinitron BVM-A14F5U Operation Manual

Structure of the COLOR TEMP ADJ
Menu
Level 1 Level 2
PRESET VALUE
MANUAL... [B1] MANUAL ADJUST [B11]
ORIGINAL VALUE
SIGNAL
CONT/BRT HOLD
AUTO... [B2] AUTO ADJUST [B21]
TARGET COLOR TEMP
X
Y
LOW LIGHT (20 IRE)
HIGH LIGHT (100 IRE)
PROBE
CONT/BRT HOLD
COPY FROM... PRESET VALUE... [B31]
[B3] (available in
OTHER MONITOR...
software version
[B32]
1.10 or higher)
MEMORY STICK...
[B33]
RESTORE
FACTORY DATA
[B4]
ANALYZE [B5]
Setting Lists in the COLOR TEMP
ADJ Menu
This section explains the setting lists displayed in the
menu.
How to read the setting lists
• For purposes of explanation, each setting list is preceded
by a menu number. These numbers are not displayed on
the screen.
For more information on the menu number, see "About
menu numbers" on page 23.
• The arrow mark (k) refers you to another setting list
that appears after you make the setting, or to an operation
that is to be carried out as a result of the setting.
[B] COLOR TEMP ADJ menu
Level 3
MONITOR ID... [B321]
MEMORY STICK
[B331]
[B1] MANUAL... menu
PRESET VALUE: The color temperature data set in
the INPUT CONFIGURATION menu is displayed.
To change the color temperature data to be
adjusted, select from D93, D65, D61, USER1,
USER2, USER3, USER4 and USER5.
When D93, D65 or D61 data is changed, they are
displayed as D93*, D65* or D61*.
When the color temperature data is changed
When the preset data is changed and you press the
MENU button to return to the main menu, the
following message appears to confirm the settings.
CHANGE INPUT CONFIG?
COLOR TEMP PRESET
DXX*
(previous color temp value) t (new color temp
value)
OK: Press the ENTER or Ent button to change the
color temperature data.
The color temperature data set in the INPUT
CONFIGURATION menu is changed to the new
data.
CANCEL: Press the MENU button to cancel
changing the color temperature data and to return to
the main menu.
The setting of the color temperature data is
remained but the color temperature data set in the
INPUT CONFIGURATION menu is not changed.
For information about the INPUT
CONFIGURATION menu, see "
Input Configuration – INPUT CONFIGURATION
Menu" on page 34.
MANUAL...: Adjust the color temperature with the
MANUAL knob. k[B1]
AUTO...: Adjust the color temperature automatically
k[B2]
COPY FROM...: Copy the other color temperature.
k[B3]
RESTORE FACTORY DATA: Reset the color
temperature to the default setting. k[B4]
ANALYZE: Read the color temperature and
luminance value. k[B5]
MANUAL ADJUST: Adjust the gain and bias with
the knobs. k[B11]
ORIGINAL VALUE: Set the initial value.
Select one from among D93, D65, D61, USER1,
USER2, USER3, USER4 and USER5.
When D93, D65 or D61 data is changed, they are
displayed as D93*, D65* or D61*.
SIGNAL: Select the white signal to be used for
adjustment.
[B] Adjusting the Color Temperature – COLOR TEMP ADJ Menu
t USERX
[C]
Setting the
31