Auto-Docking Assembly Side Rails - IBM C1B 1.12 Brick On Sled Carrier 128-pin HPC Specification Sheet

O E M FUNCTIONAL SPECIFICATION ULTRASTAR XP (DFHC) SSA MODELS 1.12/2.25 GB - 1.0" H I G H

4.2.4 Auto-docking Assembly Side Rails

IBM supplied side rails that can be used for the auto-docking assembly are shown in Figure 17 on page 61
along with mounting location information. Refer to the figure for the following notes:
Note 1: With the side rails mounted within the given tolerances, there will be a nominal 1.5 millimeter
interference between the handle and side rail to provide positive retention of the carrier and the
handle.
Note 2: The IBM part number of the auto-docking side rails is 36G6422.
Page 60 of 87
USER RESPONSIBLE F O R VERIFYING VERSION A N D COMPLETENESS
IBM Corporation
Source filename=MECHANIC