Build Serviced Objects; Place The New Tivoli Adsm For Vm Service Into Production - IBM TIVOLI ADSTAR 5697-VM3 User Manual

vmfview build

7.2.5 Build Serviced Objects

vmfbld ppf 5654A09A {ADSM | ADSMSFS} (serviced
vmfview build

7.2.6 Place the New Tivoli ADSM for VM Service into Production

access 4e2 e
access 491 f
vmfcopy * * e = = f1 (prodid 5654A09A%ADSM olddate replace
34
Tivoli ADSM for VM Program Directory
2
Use VMFVIEW to review the build status messages, and see what objects
need to be built.
1
Rebuild Tivoli ADSM for VM serviced parts.
2
Review the build message log ($VMFBLD $MSGLOG). If necessary, correct
any problems before going on. For information about handling specific error
messages, see VM/ESA: System Messages and Codes, or use on-line HELP.
1
Copy the serviced files from the test BUILD disk onto the production BUILD
disk using VMFCOPY.
Use ADSM for installing on minidisks or ADSMSFS
for installing in Shared File System directories.
Note: If your software inventory disk (51D) is not
owned by the MAINT user ID then make sure the
VMSESE PROFILE reflects the correct owning
user ID.
4E2 is the test BUILD disk where the production
files were updated by the service.
491 is the production BUILD disk where the
production files must be copied to.
VMFCOPY is used to copy the production files
since it will update the VMSES PARTCAT file on
the 491 disk.