Connecting to the TV
In order to operate the TV using a Smart Touch Control, you must first pair it to the TV via Bluetooth. However, the Smart
Touch Control is only available for the paired Samsung TV.
1. When the TV is off, point the Smart Touch Control at the remote control receiver of the TV and press the TV button
for the first pairing. Only this buttons sends an IR signal. The remote control receiver's location may vary depending
on the model.
2. A Bluetooth icon will appear at the bottom left of the screen as shown below. The TV will then attempt to connect to
the Smart Touch Control automatically.
Reconnecting the Smart Touch Control
<The Smart Touch Control pairing button>
If you need to reestablish the connection between the TV and the Smart Touch Control, press
the pairing button at the back of the Smart Touch Control toward the Remote receiver of the
TV. The pairing button can be accessed by removing the Smart Touch Control's battery cover.
Pressing the pairing button automatically reestablishes the connection between the control and
Battery Low Alarm
If the battery becomes and blanks low while using the Smart Touch Control, the following alarm
window blinks and appears at the bottom left of the screen. If the alarm window pops up, replace
the batteries of the Smart Touch Control. Use alkaline batteries for longer usage.
Inserting the Batteries (AAA X 2)
1. Slightly lift the battery cover using a plastic card. Next, pull on the cover's notch with a fingernail to remove the cover
Check the location of the battery cover groove. The groove's location may vary depending on the type of
Smart Touch Control is provided with the product.
2. Insert 2 AAA batteries, making sure to align the positive and negative ends correctly.
3. Align the battery cover with the back of the remote control and press down along the edges until it is cleanly
attached to the remote control.
<Attempting to connect and completion icons>
English - 7