Fader Start Playback; Relay Play Using Two Players - Pioneer CDJ-200 Operating Instructions Manual

7 Changing the loop-out point
1. Press the OUT/OUT ADJUST button during loop playback.
¶ The time of the out point is shown in the display, the OUT/OUT
ADJUST button starts to flash rapidly and the IN/REALTIME
CUE/HOT LOOP button indicator turns off.
2. Press one of the SEARCH buttons (1, ¡) or turn the jog
dial.
¶ The loop-out point is moved forwards or backwards in 1-frame
units.
¶ The loop-out point cannot be moved before the loop-in point.
¶ During playback of MP3s, loop adjustment is only possible
within one and the same track set having a cue point.
¶ Pressing the OUT/OUT ADJUST button or waiting 30 seconds
or longer will cause the player to exit from the loop-out adjust
mode and to resume loop playback.
7 Returning to loop playback (RELOOP)
After loop playback has been stopped, press the RELOOP/
EXIT button during playback.
¶ The player will return to the currently defined loop start point
and begin loop playback again from that point. The length of
the loop will be the same as the one first set, even if the loop
cutter was subsequently used.
¶ During playback of MP3s, re-looping is possible only within the
same folder.

Fader Start Playback

The supplied control cable may be used to connect the CONTROL
connector of the CDJ-200 to the matching CONTROL connector on a
DJM-300, DJM-500, DJM-600, DJM-3000, DJM-909 or DJM-707 DJ
mixer, thus making it possible to exit from cueing standby mode and
start playback immediately by raising the channel fader on the DJ
mixer. The cross fader may also be used to perform fade-in starts on
the player as well. The fader may also be returned to its original posi-
tion to return the player to the cueing point (back cueing.) (See P.6 for
instructions on connecting the units.)

Relay Play Using Two Players

By using the supplied control cable to connect the CONTROL connec-
tors of two CDJ-200, or other CDJ series CD players, relay play can be
performed. P.6
¶ Set both players' auto cue function to ON (The [A.CUE] indicators
will light in the displays.)
¶ Set the DJ mixers Cross Fader control to its center position.
1. Begin playback on the first player.
2. When the currently playing track ends, playback will begin
automatically on the standby player.
3. The first player will enter cue pause mode at the beginning
of the next track on its disc.
¶ By repeating this operation, the two players can be used to per-
form continuous relay play.
¶ By loading new discs and choosing desired tracks on the player
in standby, a continuous program of selected tracks can be
played.
¶ By setting a cue point on the standby player, a relay of any
desired cue point of the selected track can be performed.
P.13 "Cue Point Settings"
Note:
¶ Relay play may not operate properly if the AUDIO
OUT jacks on the two players are not connected to
the same DJ mixer.
¶ If the power to one player is turned off during its
playback, the other player may begin playback.
¶ Fader start and relay play cannot be performed si-
multaneously, since different control cord connec-
tions are required.
OPERATIONS
15