Use Of Extension Cords - Black & Decker JS660 Instruction Manual

E
G

USE OF EXTENSION CORDS

Make sure the extension cord is in good condition before using. Always use the proper size
extension cords with the tool – that is, proper wire size for various lengths of cord and heavy
enough to carry the current the tool will draw. Use of an undersized cord will cause a drop in
line voltage resulting in loss of power and overheating. For proper size cords see chart
below.
120V
Volts
240V
More
Ampere Rating
Than
0
6
10
12
MOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means your
tool will operate on standard 60 Hz household power. Do not operate AC tools on DC. A
rating of 120 volts AC/DC means that you tool will operate on standard 60 Hz AC or DC
power. This information is printed on the nameplate. Lower voltage will cause loss of power
and can result in over-heating. All Black & Decker tools are factory-tested; if this tool does
not operate, check the power supply.
Minimum Gauge for Cord Sets
0-25
Total Length of Cord in Feet
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
- 6 18
- 10 18
- 12 16
- 16 14
F
26-50 51-100
51-100 101-200
American Wire Gauge
16 16
16 14
16 14
12 Not Recommended
6
101-150
201-300
14
12
12