Installation
Connecting to a Monitor
Please connect the video output terminal located on the back of the camera to the
monitor.
•The connection method varies depending on the type of monitor and accessories.
Please refer to the user's manual for each instrument.
•Please turn off the power when connecting.
•Please select Hi-Z on the 75Ω/Hi-Z switch for the intermediate video TV set
and select 75Ω for the Intermediate device as shown in the picture below.
DOME Camera
COLOR DOME CAMERA
14
Intermediate
Monitor
BNC
User's Manual
Connecting to Power
Connect the adaptor to the power input connector as shown in the figure below.
The recommended adaptor specification for SID-45CN/CP, SID-46CN/CP is DC 12V,
500mA .
DC Power Type (DC 12V, 500mA)
DOME Camera
Power Input Connector
When the resistance value of copper wire is at [20°C(68°F)]
2
Copper wire size (AWG)
#24(0.22mm
)
#22(0.33mm
Resistance (Ω / m)
0.078
Voltage Drop (V/m)
0.028
•As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to the
camera may affect the performance of the camera.
*Standard voltage for camera operation : DC 12V±10%
*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
Notes
• Adaptor isn't offer to accessory.
• Please check the polarity of the DC power source before connecting to power.
COLOR DOME CAMERA
Adaptor
2
2
2
)
#20(0.52mm
)
#18(0.83mm
)
0.050
0.030
0.018
0.018
0.011
0.006
15
User's Manual