. Make sure dry/steam selector is set to
Note: It is recommended that you empty the water before dry
ironing (see EMPTYING THE WATER TANK).
. Turn the fabric select dial to the appropriate setting for
your fabric (E). See fabric guide on the heel rest and
read garment's label to help you determine fabric type.
The temperature-ready light glows until it reaches the
appropriate temperature. It then cycles on and off during
. When finished ironing, turn the fabric select dial to lowest
heat setting, move the selector to
Stand the iron on its heel rest and allow it to cool off.
Important: Always stand the iron on its heel rest when powered on but not
You can use spray at any setting. Check that the water tank is filled with water.
button. If spray is weak, pump the button a few times.
EMPTYING THE WATER TANK
Note: It is not necessary to empty the water after each use.
. Turn the fabric select dial to
iron on its heel rest and allow it to cool off.
. Empty the water by holding the iron over a sink with the tip
pointing down. Water will empty out of water-fill opening (F).
and unplug the iron.
. Unplug the iron. Stand the
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified
CLEANING OUTSIDE SURFACES
. Make sure iron is unplugged and has cooled completely. Wipe the soleplate
and outer surfaces with a soft cloth dampened with water. Never use
abrasives, heavy-duty cleansers, vinegar or scouring pads that may
scratch or discolor the iron.
. After cleaning, steam iron over an old cloth to remove any residue from the
STORING YOUR IRON
. Check that the selector is set to
. Unplug the iron. Stand the iron on its heel rest and allow it to cool off.
. Store vertically on its heel rest to prevent water leaking from the soleplate,
or you can empty the water tank.