Hitachi DF2200 Owner's Manual page 53

DVD Mode (Cont.)
DVD Menus
The DVD Player function of this TV set contains different settings menus
where you can program your preferred settings. Once you have programmed
any settings, the unit will retain them in its memory until you change them,
even when switching the unit to standby mode. This means you can always
operate the system under the same conditions.
Menu navigation
Press the D.SETUP button on the remote control.
Use the / /
display the setup page where you can adjust values.
Use the / /
setting.
Press the D.SETUP button again to close the setup menu.
Use the / buttons to switch to another main setup item. Then press the
or OK button to enter the submenu page.
Press the button to return to the previous menu page.
General setup page
TV Display: This setting is for selecting
the TV output mode. Available options:
Normal/PS (Pan & scan mode)
Normal/ LB (Letter box mode)
Wide: 16:9 (wide screen mode)
OSD Language: This is for choosing
your desired OSD language.
Screen Saver: Set to ON, a screen
saver will appear if the unit is left idle
and no operation is carried out for five minutes.
Last Memory: Enter another input source (except USB/Card) during disc
playback, and then back to DVD input source again, this unit will resume
playback from the point where last playback was stopped, if Last Memory is
set to ON.
Source: This is used to select your input source (DVD, Card or USB) in DVD
mode (see pages 42-43 for details).
/
buttons to select the preferred item, then press OK to
/
buttons to adjust the item, then press OK to confirm the
47