REAR SEAT/FULLY RECLINING SEAT BENCH*
The rear seat/reclining seat bench can
be converted into a large sleeping area.
Before doing this, the backrests of the
center row of seats must be tipped for-
wards. The latching levers are located on
the outsides of the right and left hand
To convert reclining seat bench
Remove head restraints*
see page 12.
Unlatch the backrest with the release
grip on the reverse side of the backrest,
and fold the backrest forwards.
By pulling the release grip further to-
wards the front, the backrest and seat
bench are pulled in a forward direction.
Finally, fold the seat backrest fully to
the rear to form a flat sleeping area.
Returning seat bench to original
Pull the seat backrest upwards out of
the horizontal position.
Slide the seat bench, together with
backrest to the rear again.
Push backrest back into locking posi-
Pull the seat belts out again between
backrest and seat, so that they are in a
position for use.
Install head restraints*-see page 12.
The space underneath the seat benc
can be used as a storage compartmen
For this, it is necessary to lift the se
bench slightly at the front. It will rema
in the lifted position when the strut, l
cated on the left on the sliding door sid
is swung upwards.
www.WestfaliaT3.info - a useful website for owners and enthusiasts of VW Westfalia T25 / T3 / Vanagon Campervans