Programming - Miele DG 1450 Operating Instructions Manual

Programming

The standard settings listed in the chart can be altered. Several settings can be
altered in succession.
Programme
P 1
P 2 Demonstration
mode
P 3 Audible tone
volume
P 4 Water hardness**
P 5 Temperature unit
P 6 Pre-heat
P 7 Keypad tones
* The factory setting is shown in bold.
**Water hardness
You can use the test strip supplied to check the water hardness level, or your local
water supplier will be able to advise you on the water hardness of your area. The
water hardness is shown as settings I to IV equivalent to the German scale 1 to
>21 °dH (0.2 >3.8 mmol/l).
24
Status*
S 0
S 1 Factory default settings reinstated
S 0 Off, the appliance will heat up
S 1 On, the appliance will not heat up
S 1 Very quiet
S 2 Quiet
S 3 Medium
S 4 Loud
Hardness setting Hardness range
S 1
S 2 II
S 3 III
S 4 IV
S 1 Unit in °C
S 2 Unit in °F
S 0 Pre-heating not active
S 1 Pre-heating active
S 0 Off
S 1 On
I
(0.2-1.3 mmol/l)
(1.4-2.5 mmol/l)
(2.7-3.8 mmol/l)
>21 °dH (above 3.8 mmol/l)
1-7 °dH
8-14 °dH
15-21 °dH