Carrying Out Auto Ta And Eq - Pioneer Premier DEH-P980BT Operation Manual

Section
15 Audio Adjustments
— When delays occur for low sounds due
to the influence of the LPF on active
subwoofers or external amps.
! Auto TA and EQ changes the audio settings
as below:
— The fader/balance settings return to the
center position. (Refer to page 81.)
— The graphic equalizer curve switches to
Flat. (Refer to page 85.)
— When a subwoofer is connected to this
unit, it will be adjusted automatically to
both subwoofer output and high pass fil-
ter setting for rear speaker.
! If you carry out auto TA and EQ when a pre-
vious setting of this already exists, the set-
ting will be replaced.

Carrying out auto TA and EQ

CAUTION
Never use the microphone for hands-free phon-
ing to operate the auto TA and EQ. Using the mi-
crophone unfit for the auto TA and EQ may
damage the speaker. Be sure to connect the
AUTO TA&EQ microphone into the microphone
input jack.
1 Stop the car in a place that is as quiet
as possible, close all doors, windows and
the sun roof, and then turn the engine off.
If the engine is left running, engine noise may
prevent correct auto TA and EQ.
2 Fix the supplied microphone in the cen-
ter of the headrest of the driver's seat, fa-
cing forward, using the belt (sold
separately).
The auto TA and EQ may differ depending on
where you place the microphone. If desired,
place the microphone on the front passenger
seat to carry out auto TA and EQ.
90
En
3 Turn the ignition switch to ON or ACC.
If the car's air conditioner or heater is turned
on, turn it off. Noise from the fan in the air
conditioner or heater may prevent correct auto
TA and EQ.
# Press SOURCE to turn the source on if this
unit is turned off.
4 Select the position for the seat on
which the microphone is placed.
Refer to Using the position selector on page
81.
# If no position is selected before you start auto
TA and EQ, Front Left is selected automatically.
5 Press SOURCE and hold until the unit
turns off.
If anything is connected to the microphone
input jack, disconnect it.
6 Press and hold EQ to enter the auto TA
and EQ measurement mode.
7 Plug the microphone into the micro-
phone input jack on this unit.
AUTO TA&EQ microphone