Table of Contents
Advertisement
AUX
ON • OFF
Indicator
REV•REPLAY
PLAY
STOP
Use these buttons when
you program the remote.
Important: The remote may not be
compatible with all models of all brands of
components. It may not operate all
functions of the remote that came with
your component.
Important
You must continue pressing the
component button while you enter the
code.
Let's say you have a Zenith TV. To
program the universal remote to
operate the TV, you would:
Press and hold the TV button while you
enter the first code listed for Zenith in
the TV Codes column.
Release the TV button. Press ON•OFF
to see if the TV responds. If it doesn't,
follow the same steps, but enter the
second code for Zenith TVs instead of
the first.
Note
Some of the remote's buttons might
operate differently for other
components, especially when you're
using another component's menu
system.
Chapter 2
TV
Illustrations contained in this document are for representation only.
Chapter 2: Remote Control
Programming the Remote to Operate Other
Components
The universal remote can be programmed to operate most
brands of remote controllable components. The remote is
already programmed to operate most RCA, GE, and Proscan
components.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be
programmed for your component, turn the component ON.
For example, to program the remote for a TV, turn on the TV.
Point the remote at the TV, and press the TV button. Then
press ON•OFF or CH + (channel up) or CH – (channel down)
to see if the TV responds to the remote commands. If the
component does not respond, the remote needs to be
programmed.
Programming the Remote
There are two ways to program the remote control: direct
entry and automatic code search.
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component
on the code list in this section.
3. Point the remote at the component. Press and hold the
component button you want to program on the remote
(TV or AUX).
4. Enter the 4-digit code from the remote control code list
on the following pages. If the indicator flashes, you have
either entered an invalid code or the button isn't
programmable.
5. Release the component button, and then press ON•OFF to
see if the component responds to the command. If it
doesn't, try pressing the component button and then
ON•OFF again.
• If you get no response, repeat these steps using the next
code listed for your brand, until the component responds
to the remote commands.
• If you try all the codes for your component brand and
none work, try the automatic code search method. If
automatic code search doesn't work, the remote is not
compatible with your component.
13
Advertisement
Table of Contents
