Operating Other Components - Kenwood VR-506 Instruction Manual

The remote control supplied with this receiver (for VR-506/517/
KRF-V6050DN5550D only) is also capable of controlling com-
ponents from a variety of manufacturers once you register the
appropriate setup codes into the remote control unit
Replace all four batteries with new ones when you notice a shortening
control is designed to retain setup codes in memory while you change
Registering setup codes for other components
-*
POWER
Numeric keys
Source
POWER
keys
c3
RC-R0615/R0617
q
Find the setup code of the component to be registered
l
Refer to the setup code lists to find the setup code for the component
to be registered
-a
Example: To register a DVD made by KENWOOD, you would enter
"805"
1 Input 1 Component 1 Maker 1 Code 1 Key 1
1 (DVD) 1 DVD player 1 KENWOOD 1 805,808 1 DVD 1
q
Hold down the POWER key and press the numeric keys to
enter the setup code.
l
Example: Press "805" to register a DVD player made by KENWOOD
l
If you push an invalid key, the remote will exit the setup mode
q
Press the source POWER (TV, IICR, BIIB, CABLE, DSS)key
for more than 2 seconds, and check to see that the
component you want to control turns on
If the component does not react, and there is more than one
setup code, enter another setup code and try again
l
F/II, TUNING 44-, or MULTI CONTROL key(s) can also be used
instead of the POWER key
l
If the component is already on, pressing thesource POWER keys will
turn it off
q
Repeat steps H to El to register additional components
until all components have been registered
Note
Although each setup code is designed to work with a number of different
models, certain codes may not work with some models (Also, certain
codes may only operate some of the functions available on a given
model )
Operating other components
This operation lets you operate the registered components
KENWOOD audio components with system control turn on and off
automatically with the receiver via the system control connections
POWER
Source
POWER
keys
RECEIVER
RC-R0615lR0617
q
$&;e input selector keys to select the component you
l
Pressing the input selector keys also changes the input selector on
the receiver
l
When you operate your registered TV, VCR, DVD player, Cable
tuner, or DSS receiver, go to step lil
l
When you operate the CD player, Cassette deck, MD player, or
Tuner with system control connection, go to step
q
q
Press the source POWER key.
q
Press the operation keys you desire
-a
l
To return to the receiver operation mode, press the RECEIVER key
The remote control mode returns to the receivgf operation mode
when you do not operate for more than 15 seconds
Note
Be sure to point the remote control at the remote sensor on the receiver
when you want to operate KENWOOD components connected by
system control cords Otherwise, point the remote control at the compo-
nent you want to operate