Pioneer AVD-W6200 Owner's Manual page 31

1. Push the lock release button, then slide and remove the headrest upward.
Note:
• The supplied mounting arm may not be installed on seats where the lock release button does not
face outside.
2. Adjust the shaft guides so that the shafts pass through the mounting arm.
Choose holes that match the shafts, then adjust the positions of the shaft guides to match
the width between the shafts.
7 7 Removing and setting the shaft guides.
To remove the shaft guides,
push them from the bottom
side of the mounting arm.
You can slide the left side guide to make adjustments.
Note:
• The suitable width between the shafts is between 120mm (4-3/4 in) and 190mm (11-5/8 in).
Adjust the position of the shaft guides to the length shown.
You can change the direction
of the left side guide.
Examples: Positions of the shaft guides
The widest model
(190 mm [11-5/8 in])
Head rest
Shaft
Boots
Choose a hole that matches the shaft diameter.
Lock the shaft guides in position.
The right side guide can
only be set at either end.
The narrowest model
(120 mm [4-3/4 in])
You cannot change the
direction of the right side
guide.
30