Receiver Settings - Dog trace d-fence User Manual

Receiver Settings

Description
1 - Contact Points 2 - Strap 3 - Target 4 - LED indicator
Battery Insertion and Replacement
Unscrew the 4 screws of the top of the receiver using a cross-head
screwdriver and remove the lid. Insert the 3V lithium CR2 battery into the
battery compartment. Please check that the battery is installed with correct
polarity (according to the polarity marks inside the battery compartment
- see the picture). Wrong polarity may damage the unit. Approximately
after a second, the receiver will beep if the battery is inserted correctly.
Before putting the lid of the receiver back in place,
make sure that the rubber seal is correctly seated
in its groove. Lubricating the seal with a thin layer
of silicone grease will increase it's lifespan. Screw
down the 4 screws of the top tightly (do not over
tighten them).
8
1
Battery polarity marks
2
3
4