Download Table of Contents Print this page

Maintenance; Carburetor; Muffler - Husqvarna 125C Operator's Manual

Husqvarna gas hedge trimmer operator's manual
Hide thumbs Also See for 125C:

Advertisement

Table of Contents
The owner is responsible for the perfor-
mance of all required maintenance as
defined in the operator's manual.

Carburetor

Your Husqvarna product has been designed
and manufactured to specifications that re-
duce harmful emissions. After the engine
has used 8- -10 tanks of fuel, the engine will
be run- -in. To ensure that it continues to run
at peak performance and to minimize harm-
ful exhaust emissions after the run- -in peri-
od, ask your servicing dealer to adjust your
carburetor.
WARNING!
clutch cover, and shaft must be
fitted before the machine is started,
otherwise parts could come loose
and cause personal injury.
Function
S The carburetor governs the engine's
speed via the throttle control. Air and fuel
are mixed in the carburetor.
S The T- -screw regulates the throttle setting
at idle speed. If the T- -screw is turned
clockwise this gives a higher idle speed;
turning it counterclockwise gives a lower
idle speed.
Basic setting
S The basic carburetor settings are ad-
justed during testing at the factory. Fine
adjustment should be carried out by a
skilled technician.
CAUTION! If the cutting attachment rotates
when the engine is idling the idle adjustment
screw T should be turned counterclockwise
until the cutting attachment stops.
Rec. idle speed:
See "Technical data" section.
Recommended max. speed:
See "Technical data" section.
WARNING!
cannot be adjusted so that the cut-
ting attachment stops, contact your
dealer/service workshop. Do not use
the machine until it has been cor-
rectly adjusted or repaired.
Fine adjustment of the idle
speed- -T
Adjust the idle speed using the idle adjust-
ment screw- -T if it is necessary to readjust.
First, turn the idle adjustment screw- -T
clockwise until the cutting attachment starts
to rotate. Then, turn the screw counterc-
lockwise until the cutting attachment stops.

MAINTENANCE

The complete clutch,
If the idle speed
The idle speed is correctly adjusted when
the engine will run smoothly in every posi-
tion. The idle speed should also be well
below the speed at which the cutting at-
tachment starts to rotate.
WARNING!
not be adjusted so that the cutting
attachment stops, contact your ser-
vicing dealer. Do not use the ma-
chine until it has been correctly ad-
justed or repaired.
Unit/Maintenance Safety
Disconnect the spark plug before perform-
ing maintenance, except carburetor adjust-
ments.

Muffler

CAUTION! Muffler is fitted with a catalytic
converter designed to reduce harmful ex-
haust gases.
The muffler is designed to reduce the noise
level and to direct the exhaust gases away
from the operator. The exhaust gases are
hot and can contain sparks, which may
cause fire if directed against dry and com-
bustible material.
Mufflers are equipped with a special spark
arrestor mesh. The mesh should be
checked and, if necessary. cleaned by a
servicing dealer. If the mesh is damaged,
it should be replaced. If the mesh is fre-
quently blocked, this can be a sign that the
performance of the catalytic converter is
impaired. Contact your servicing dealer to
inspect the muffler. A blocked mesh will
cause the machine to overheat and result
in damage to the cylinder and piston.
16
Idle Speed
Screw- -T
If the idle speed can-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

125c, 125l125l

Table of Contents