Related Manuals for Herron Audio VTSP-2
Summary of Contents for Herron Audio VTSP-2
- Page 1 Owner’s Manual VTSP-2 VTSP-2 Vacuum Tube Vacuum Tube Stereo Preamplifier Stereo Preamplifier...
-
Page 2: Table Of Contents
Front Panel Features performance while maintaining conservative operation for extended tube Remote Control life. As with all Herron Audio products, the VTSP-2 is engineered to be reli- able and user friendly. Rear Panel Features Manufacturing of the VTSP-2 is performed under the tightest of quality Installation and Operation controls. -
Page 3: Features
38kHz modulation and detection At startup, the display on the VTSP-2 NOTE: When the invert mode of the power line polarity connection to of this signal initiates the VTSP-2’s... -
Page 4: Design Considerations
• Unity gain pass-through function—initiated by holding video button displays. age is brief, the unit will mute and The VTSP-2 has an instant shut- wait 10 to 15 seconds to unmute • Non-multiplexed display, eliminating radio and audio interference down circuit that mutes the output when the power is restored. -
Page 5: Front Panel Features
Herron Audio Vacuum Tube Stereo Preamplifier Owner’s Manual Front Panel Features Front Panel Features NOTE: The balance control from the front panel or the remote cannot be operated from the control. remote. The orange “Mono” light indi- The “Volume” knob operates a cates that the preamplifier is in... -
Page 6: Remote Control
Power Connection the remote. The V button on the the VTSP-2. The remote control uses 2 • With the mute engaged set the left decreases the volume. The V CR2025 3-volt lithium batteries. An IEC power cord connector is... -
Page 7: Installation And Operation
The allow monitoring of the selected such as motors, transformers, 7. Power up the VTSP-2 by left/right input pairs are arranged ver- audio signal after the input relays. etc. Magnetic fields of this switching on the power switch. -
Page 8: Changing Tubes
CAUTION ! ! ! ! ! When changing tubes, the VTSP-2 should be unplugged and left off for a minimum of 30 minutes prior to opening the unit to insure that haz- ardous voltages in the power supply have time to discharge before entering the unit. -
Page 9: Technical Specifications
Herron Audio Vacuum Tube Stereo Preamplifier Technical Specifications Technical Specifications Frequency response: 1 Hz to beyond 100 kHz, 20 Hz to 20 kHz 0.1 dB Output Impedance: 100 ohms nominal at 1 kHz Input impedance: 100,000 Ohms Gain: 14 db...
Need help?
Do you have a question about the VTSP-2 and is the answer not in the manual?
Questions and answers