Assembly ................................................................. 4 - Husqvarna 917.29939 Owner's Manual

ASSEMBLY
UNPACK CARTON & iNSTALL HANDLE
See Fig. 2)
CAUTION: Be careful of exposed staples
when handling or disposing of carton=
ing material.
IMPORTANT:WHEN UNPACKINGAND ASSEMBLING TILLER,
BE CAREFUL NOT TO STRETCH OR KINK CABLE(S).
Cut cable ties securing handle column.
Route cable(s) as shown and slide handle column onto
handle mount.
• Remove all packing from carton.
• Secure handle column using two (2) carriage bolts and
two (2) flange Iocknuts. Tighten securely.
• Cut away carton.
• Route tine control cable(s) through plastic cable clip
on handle mount.
NOTE: Cables must not touch the muffler.
Cut cable ties securing tiller to skid. Remove tiller from
skid by pulling backwards.
Remove screws securing depth stake to skid and dis-
card the screws.
TINE
CONTROL
CABLES
TINE
HANDLE
MOUNT
i/_..--.---HANDLE
COLUMN
CARRIAGE
BO_
FLANGE
LOCKNUT
iNSTALL DEPTH STAKE ASSEMBLY
(See Fig. 3)
Loosen nut '_'.
• Insert stake support between engine bracket halves
with stake spring down.
• Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut '_'.
• Depth stake must move freely. If it does not, loosen
support bolt.
ENGINE BRACKET
HALVES
NUT "A"
DEPTH STAKE
SUPPORT
STAKE
SPRING
DEPTH
STAKE
HEX BOLTS,
LOCK WASHERS,
AND HEX NUTS
SUPPORT
BOLT
Fig. 3
HANDLE HEIGHT
Handle height may be adjusted to better suit operator.
(See "HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle your
tilling conditions (See "TINE ARRANGEMENT" in the
Service and Adjustments section of this manual).
TiN E OPERATION
Check tire operation before first use. (See "TINE OP-
ERATION CHECK" in the Service and Adjustments
section of this manual).
Fig. 2
5