Locking/Unlocking The Vsi; Off-Board Charger Socket; Controller Connector; Sleep Mode - Pride Mobility Go-Chair Owner's Manual

Hide thumbs Also See for Go-Chair:
Table of Contents

Advertisement

Locking/Unlocking the VSI

The VSI has a feature that enables you to lock your Go-Chair to prevent unauthorized use.
To lock the VSI:
1. With the VSI switched on, press and hold the on/off key. After 1 second, the VSI should beep.
2. Release the on/off key.
3. Push the joystick to the full forward position until the VSI beeps.
4. Pull the joystick to the full rearward position until the VSI beeps.
5. Release the joystick. There should be a long beep.
6. The VSI is now locked.
To unlock the VSI:
1. Press the on/off key and power on the VSI. The maximum speed/profile indicator should ripple side to side.
2. Push the joystick to the full forward position until the VSI beeps.
3. Pull the joystick to the full rearward position until the VSI beeps.
4. Release the joystick. There should be a long beep.
5. The VSI is now unlocked.
NOTE: If the above procedure fails to either lock or unlock the VSI, contact an authorized Pride Provider.

Off-board Charger Socket

You may use an off-board charger to charge the Go-Chair batteries through the 3-pin socket located on the front of the VSI.
The off-board charger current should not exceed 5 amps. Contact an authorized Pride Provider for more information.
WARNING! Only authorized Pride chargers should be connected to the off-board charger socket.
See an authorized Pride Provider for more information.
NOTE: The off-board charger socket on the controller should be used when charging the batteries with the
battery box installed on the power base.

Controller Connector

This connects the VSI to the travel chair's batteries, motors, and motor brakes.

Sleep Mode

The VSI controller is equipped with a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off the
main power if the joystick is not moved in any direction for a preset period of time. The battery condition meter lights on
the keypad indicate sleep mode by blinking once every five seconds. To restore power and continue, push the on/off
key twice.
30
V I I .
O P E R A T I O N
www.pridemobility.com
Go-Chair

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents