Download Print this page

Husqvarna 96193006300 Operator's Manual page 8

Walk-behind snow throwers
Hide thumbs

Advertisement

MUF FLER
GAS O LINE
FILLER CAP
CHOKE
CON-
TROL
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
PRIM ER
FUEL SHUT-OFF VALVE
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AU GERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
en gine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Throttle/engine control - used to se lect either FAST or
SLOW engine speed and to STOP the engine.
ON / OFF switch - used to STOP the engine.
OPERATION
ELECTRIC
START
BUTTON
POWER
CORD
PLUG
DE FLEC TOR
DISCHARGE
CHUTE
CLEAN-OUT TOOL
FIG. 8
8
AUGER
DISCHARGE CHUTE CONTROL LEVER
CONTROL
LEVER
DRIVE SPEED
CON TROL LEVER
CHUTE
Choke control - used for starting a cold engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the di-
rec tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
TRACTION
DRIVE
CONTROL
LEVER
LIGHT
CHUTE
DE FLEC TOR
KNOB
HANDLE
KNOB
MUF FLER
TOOLBOX
SKID PLATE

Advertisement

loading

  Related Manuals for Husqvarna 96193006300

This manual is also suitable for:

924sb