Figure 20 – Loading Media Over Platen Roller; Figure 21 – Positioning Media Guides And Sensor - AMT Datasouth Fastmark 600 Series User Manual

Fastmark 600 series with pal print and program language barcode label printer

Hide thumbs Also See for Fastmark 600 Series:

Table of Contents

6. With the printing side up, feed the Media off the Media Roll under the Print Head

Module and over the platen.

Figure 20 – Loading Media over Platen Roller

7. Position the Media Sensor to the desired location.

To position the Media Sensor examine the back of the Media Stock. As the media is

pulled through the printer position the sensor to avoid holes or preprinted information on

the back of the stock. These may cause incorrect top of form alignment. Typical media

stock backing is blank, therefore position the sensor in the middle of the stock.

Figure 21 – Positioning Media Guides and Sensor

8. Close the Right and Left Media Guides until the Media Stock is under the "U" shaped

guides. This will keep the stock from going side to side.

Note: The Right and Left Media Guides are 'U' shaped parts that are located at the

bottom of the paper path. Both Guides move together to hold the stock in the

Center of the printer.

Fastmark 600 Series User's Guide

Table of Contents