Figure 15 – Print Head Module Closed - AMT Datasouth Fastmark 600 Series User Manual

10. Close and latch the print head module . Be sure to press firmly on both sides so that
both latches clink into place. If either latch is not clicked into place it will cause the
media to not feed properly or light print.
Note: The printer must be set to the Thermal Transfer mode to ensure the end of ribbon is
detected. Refer to the section Feature Management Mode for instructions on how
to change the Media Type feature.
Fastmark 600 Series User's Guide
Left Latch
Figure 15 – Print head Module Closed
Right Latch
23